Remove all of the batted fiberglass insulation. Use Sterifab to disinfect the attic space. Secure the hvac supply connections with additional hvac tape. Install new baffles at the soffit lines around the entry point. Air seal gaps and conduit lines with spray foam for energy efficiency. Insulate the entry door …

Install Carbon fiber crack repair kit on foundation wall from floor to ceiling. Break up floor in front to direct any water under floor. Restore floor with concrete when completed.

Water entering top of first step, lower wall section on left side of basement. Extend new drain system from steps, down to basement. Install drain system where washing machine pad is located. Run system and tie into both sides of existing drain system. Re-pour concrete on 1st step and finish.

Remove rotted area of fascia from front left corner of home. Install small piece of fascia and paint white. Wrap both 1×6 rake boards on front and rear if townhome

Customer complaints about high humidity in lower level basement and probable mold. Apply 2 inches of closed cell foam for 95 LF through basement and 1st floor laundry room. Install AprilAire dehumidifier with condensate pump, hanger kit with duct hose and passive transfer grille in wall at family room.

Blow in all new cellulose insulation over existing insulation to reach a uniform depth of 12”. Check all baffles and replace any damaged baffles, in order to keep insulation in the proper place. Weatherstrip and insulate attic hatches.

Install all new crawl space door. Screen over crawl space vents on front of home from inside crawl space.

Install new crawlspace door, and screen over old crawl space vents with stainless steel screen.

Install one solar powered attic fan on the backside of the roof. Includes and thermostat and humidistat. A RVG (roof vent guard) will be installed to prevent wildlife entry into the attic space.

Corner of kitchen settling 1/2″ at refrigerator and base cabinets. Floor joists are 2×8 at maximum span of 12 feet. From double 2 x 8 install a double 2 x 10 carry beam, 8 LF Excavate and pour two footers to support two 6 x 6 columns.

Remove all old blown in fiberglass insulation from main attic only. Fog both attics due to wildlife activity in attic. Air seal cracks in main attic with closed cell spray foam and install new baffles as needed. Apply 13 inches of new blown in cellulose insulation giving the customer an R-value …

Build a wood baffle around the entry point. Install new baffles at the soffit line. Insulate the entry door with foam board insulation and install weather stripping for energy efficiency. Blow over the existing insulation with cellulose insulation to reach levels of 14 inch (R49). Repair the front drip edge to …

Remove all of the blown in insulation and animal feces in the attic space. Remove boards as needed. Use Sterifab to disinfect the entire attic space. Install baffles around th entry point and soffit lines. Air seal gaps and conduit lines for energy efficiency. Install can light covers over recess

Remove all old blown in debris and insulation from attic. Air seal all cracks with closed cell spray foam. Install new baffles along rafters and entry point.

Blow over 5 inches cellulose on existing batted insulation. This will bring the insulation value up to a minimum of R42.