Why did the customer contact us?

The customer needed new attic insulation.

Solutions provided:

Install GrateDrain system along rear wall from left inside doorway to right side edge of fireplace.
Install Flexiflange and drill weep holes in the block pockets along entire length,
back flush port be installed at the beginning of the run to permit servicing necessary. the customer may install flooring over the flush port but it is requested that it be left in a state that permits easy access.
Install FastSump with liner in left corner of basement with high water alarm and clear check valve.
Discharge line will be run up wall high enough to facilitate check valve installation then turn to run behind drywall to exit foundation on left side. Customer will install box to hid appearance of sump liner. Drywall will need to be removed where pipe runs up wall.
Run discharge line under surface/under fence near landscape timber into flush mounted drain box.
Customer will install dedicated electrical receptacle.
Floor will be covered with high strength concrete when finished. Customer may install flooring after a minimum of 24 hours.